I've almost done the ceiling in the aft cabin! only a few bits on the starboard side to go! It's a mix of old and new planking, so it looks a bit stripy but that will all disappear once I've painted it white

when i got to the boat this morning, I discovered the metal cover over above the wheelhouse door had given up the good fight, and was on its way to the deck! So i spent most of the morning sorting it out

I've been away for the weekend, however dad has been working on the boat. He is bending the new timber to fit to the port side.
This evening I fitted some purlin clips to support the cladding on the side of the aft cabin, it's starting to come together now :)

putting it back together

Dad has been working away fitting the new timber under the foredeck, you can spot the clean new bit in the pic!I reached a milestone today, below is the 400th brass screw that I've used to fit the planking in the aft cabin!

going green!

I decided to cycle to the boat this morning, to save a bit of diesel, i was going faster than the cars for half the journey!
I've mostly been working in the aft cabin, this afternoon I sprayed the insulation onto the back wall, and fitted some more t&g planking.

I also gave Dad a hand to remove some old screws from the foredeck. He planed the new timber to the right size this week, ready to fit under the deck

may's first monday

I'm a bit late with this one, I was too busy putting in the vast number of little brass screws that hold the Tongue and groove planking to the bulkhead. I've now got all the way across!I've also also started putting up the planking onto the ceiling, I'm going to paint this white, so i'm using some that we took down from the bow. I also put up the battern to support the wall of the Aft heads (toilet/bathroom)

Dad was racing his Jacqueline dinghy today, so it was just me working on the boat.
During the week, he has painted the wheel house doors, and been working on the foredeck.
This morning I put some more Tongue and groove on the foward bulkhead in the aft cabin, I've now done the tall part :) I'll have to make up a metal plate to finish round the exhaust pipe as I've left a 2" gap to stop it getting too singed!
I've screwed wooden batten to the opposite end of the cabin ready to insulate it and then cover it up. It's going to look a bit odd, as the window is an inch off center and not level!